HP StorageWorks 7110 Using VADIAG on HP-UX - Page 1

Using VADIAG on HP-UX Using VADIAG on HP-UX This document describes the VADIAG (Virtual Array) commands supported in the offline diagnostic environment (ODE) for HP-UX systems. VADIAG Command Summary The following table lists the VADIAG commands and their brief descriptions. Command ARRAYINDEX CLRLOG CREATELUN DELETELUN DESCRIBE DISPFILES DISPMAP DISPVOLSET DISKINFO DISKSTATE DOWNLOAD ENCLOSURE FRU FORMAT HELP INQUIRY LCCINFO LOOPPAIR RANGE READLOG Description Selects the specified array for testing. Clears the logs of either the selected controller or disk. Adds a LUN to the selected array. Removes a LUN from the selected array. Displays configuration information for the selected array. Displays the firmware images found on the ODE media. Displays the arrays connected to the specified bus. Displays the disk volume set serial number. Displays revision information for the selected array and disks installed in each JBOD enclosure. Displays the state of the disks installed in the array enclosures (including the Map disks). Downloads the image file to the specified array controller, disk, or JOBOD LCC. Selects the JBOD enclosure connected to the selected array. Selects the specified component either for testing or to get information from. Formats either the array subsystem or a disk. Lists either all VADIAG commands or detailed information for a specified command. Displays SCSI Inquiry data for the selected array controller, disk, or JBOD controller. Displays information about the JBOD LCCs connected to the array. Selects the controller loop pair. Selects a range of blocks to be tested by ROMT and WRTMT. Reads the logs of the specified controller or disk. 1