HP StorageWorks 8/40 Brocade Troubleshooting and Diagnostics Guide v6.1.0 (53- - Page 56
Brocade DCX error handling, Scenario, Error handling, Required Action
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
5 Brocade DCX error handling TABLE 9 Brocade DCX CP Error Handling Scenario When No. Scenario Error handling Required Action 1 During During downloading to 1. When the main CPU boots up, Restart step 1 the main CPU of the firmwareDownload is aborted. firmwareDownload standby CP, if an error occurs and the main CPU reboots. 2. The firmwareCommit command will be initiated on the main CPU and the after the repair is done. original firmware is restored on that CPU. 3. Both CPUs on both CPs will have the original firmware. 2 During During downloading to 1. When the co CPU boots up, Restart step 2 the co CPU of the firmwareDownload is aborted. firmwareDownload standby CP, if an error occurs and the co CPU reboots. 2. The firmwareCommit command will be initiated on both CPUs on the standby CP. after the repair is done. 3. Both CPUs on both CPs will have the original firmware. 3 During During downloading to 1. The firmwareCommit command will Restart step 1 or any of the CPUs on the be initiated on both CPU on the firmwareDownload 2 standby CP, if the standby CP and the original firmware after the repair is downloading takes too is restored on both CPUs. done. long and exceeds the 30 minute timeout for the firmwareDownload 2. Both CPUs on both CPs will have the original firmware. process. 4 During Active CP fails over 1. The firmwareCommit command will Restart step 1 or during the downloading be initiated on both CPU on the new firmwareDownload 2 to any of the CPUs on active CP and the original firmware is after the repair is the standby CP. restored on both CPUs. done. 2. Both CPUs on both CPs will have the original firmware. 5 During If the standby CP failed 1. Active CP will wait for 10 minutes and Determine why the step 4 to reboot or unable to abort firmwareDownload. CPs fail to gain HA synchronize with the active CP. 2. If the standby CP boots up, firmwareCommit will start on both CPUs on the standby CP. sync and remedy it before restarting firmwaredownload 3. Both CPUs on the standby CP will have the new firmware, and both CPUs on the active CP will have the old firmware. 6 During When downloading to 1. When the main CPU on the standby Restart step 6 the main CPU of the CP boots up, firmwareDownload is firmwareDownload standby CP, if an error aborted. after the repair is occurs and the main CPU reboots. 2. The firmwareCommit command will be initiated on both CPUs on both done. CPs. 3. Both CPUs on the standby CP will have the old firmware and both CPUs on the active CP will have the new firmware. 42 Fabric OS Troubleshooting and Diagnostics Guide 53-1000853-01