HP StorageWorks MSA 2/8 HP StorageWorks SAN Switch rack mount kit installation - Page 3
The SAN Switch Rack Mount Kit contains rails labeled, Table 1,
View all HP StorageWorks MSA 2/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Item Description Eight #10 adapter washers Two 1/4-20 hex nuts with captive star lock washers Two 1/4-inch flat washers 3. Attach the rear mounting brackets to the rear rack uprights. • For an HP 10000 Series Rack, assemble each of the brackets using two #10-32 x 1/2-inch Phillips panhead screws with captive star lock washers and two #10 adapter washers, as shown in Figure 1. • For an HP System/e Rack, install the two rear mounting brackets with two #10-32 x 1/2-inch Phillips panhead screws and two #10 alignment washers, as shown in Figure 2. CAUTION: For proper airflow, the SFP+ media side of the device port side must face the rear of the rack. This allows cool air to enter the front of the rack and exit from the rear. To install the device in a rack: 1. Verify that the required parts and hardware are available. (See Table 1.) 2. Choose a mounting location for the device in the rack. Figure 1 Installing the rear mounting brackets (HP 10000 Series Rack) Figure 2 Installing the rear mounting brackets (HP System/e Rack) NOTE: The SAN Switch Rack Mount Kit contains rails labeled Left and Right to designate the left side and right side of the device or cabinet as viewed from the front of the cabinet. Page 3