HP StorageWorks Modular Smart Array 1000 HP StorageWorks Disk Drive Modular Sm - Page 2

Removing a disk drive Caution: Do not remove more than one disk drive at a time from the enclosure. Doing so will impact cooling of the enclosure and may cause data loss. 1. Push in the port-colored ejector button (1, Figure 2) and pull the release lever (2) down to the full open position. Caution: Rotating media can make the disk drive difficult to handle. To avoid dropping and damaging the disk drive, wait approximately 30 seconds for the media to stop rotating before removing the drive from the enclosure. 2. Pull the disk drive part way out of the enclosure (3) and wait for the media to stop spinning. 3. When the media has stopped spinning, remove the disk drive from the enclosure. Figure 2: Removing a disk drive Verifying proper operation After replacing the disk drive, check the following to verify that the disk drive is operating normally: ■ Disk drive status indicators (Figure 1) should indicate the following: - Activity - On or flashing - Online - On or flashing - Fault - Off Returning the failed component Please follow the return instructions provided with the new component. 3 2 1 0004a Installing a disk drive 1. On the replacement disk drive, push in the ejector button and pull the release lever down to the full open position. 2. Insert the drive into the enclosure (1, Figure 3) as far as it will go. 3. Close the release lever (2) until it engages the ejector button, and the disk drive seats in the backplane. 4. Press in firmly on the disk drive to ensure it is seated properly. Figure 3: Installing a disk drive 1 2 0005a Page 2