HP StorageWorks NAS b2000 NAS b2000 v2 - Quick Start Guide (325881-001) - Page 17
Deploying the NAS b2000 v2 on the Network
![]() |
View all HP StorageWorks NAS b2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Product Overview Deploying the NAS b2000 v2 on the Network The default shipping configuration contains two 10/100/1000 integrated network interface controller (NIC) ports for client data access. These data ports also allow access to the Web user interface (WebUI) that accompanies the product. It is from the WebUI that most management and administrative procedures can be accomplished. The embedded Integrated Lights-Out (iLO) provides an additional management port for remote console and diagnostics. HP recommends that this connection be placed on a management LAN separate from the corporate infrastructure if it is present. The NAS b2000 v2 supports the use of NIC teaming. NIC teaming provides failover and load balancing of network ports of the NAS b2000 v2. NIC teaming requires the network cables to be installed on the same subnet to enable it to work. However, HP does not recommend the assignment of IP addresses to the ports that will be teamed or load-balanced prior to the installation and setup of NIC teaming. For this reason, HP recommends that you set all network ports to DHCP. For information concerning the configuration of NIC teaming after setup is complete, see the administration guide. 1 23 4 5 3 2 12 11 10 9 8 7 6 Figure 3: Rear panel connectors NAS b2000 v2 Quick Start Guide 17
![](/manual_guide/products/hewlettpackard-storageworks-nas-b2000-nas-b2000-v2-quick-start-guide-325881001-b40898b/17.png)