HP StorageWorks SN6000C Cisco MDS 9000 Family Fabric Manager Quick Configurati - Page 24
Step 18, Caution, Cisco MDS 9000 Family, Configuration Guide
View all HP StorageWorks SN6000C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Using the Switch Setup Utility Chapter 2 Initial Switch Configuration Send documentation comments to [email protected] Step 18 Enter on (on is the default) to configure the switch port trunk mode. Configure default switchport trunk mode (on/off/auto) [on]: on Step 19 Enter deny (deny is the default) to configure a default zone policy configuration. Configure default zone policy (permit/deny) [deny]: deny Step 20 This step denies traffic flow for all members of the default zone. Enter yes (no is the default) to enable a full zone set distribution (refer to the Cisco MDS 9000 Family Configuration Guide). Enable full zoneset distribution (yes/no) [n]: yes Step 21 You see the new configuration. Review and edit the configuration that you have just entered. Enter no (no is the default) if you are satisfied with the configuration. The following configuration will be applied: switchname switch_name interface mgmt0 ip address mgmt_IP_address subnetmask mgmt0_ip_netmask no shutdown ip default-gateway default_gateway telnet server enable no ssh server enable no system default switchport shutdown system default switchport trunk mode on no zone default-zone permit vsan 1-4093 zoneset distribute full vsan 1-4093 Would you like to edit the configuration? (yes/no) [n]: no Step 22 Enter yes (yes is the default) to use and save this configuration. Use this configuration and save it? (yes/no) [y]: yes Caution If you do not save the configuration at this point, your changes will not be updated the next time that the switch is rebooted. Type yes to save the new configuration to ensure that the kickstart and system images are also automatically configured. Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide 2-8 OL-7765-05