HP StorageWorks XP10000 HP StorageWorks XP Disk Array Configuration Guide: Non - Page 9
SNMP configuration, Installation roadmap, Installing and configuring the disk array
View all HP StorageWorks XP10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
SNMP configuration The XP family of disk arrays and the SVS 200 support standard Simple Network Management Protocol (SNMP) for remotely managing arrays. The SNMP agent on the service processor (SVP) performs error-reporting operations requested by the SNMP manager. SNMP properties are usually set from the SVP but they can also be set remotely using XP Remote Web Console or XP Command View Advanced Edition Software. Refer to the applicable user's guide for procedures. Figure 1 SNMP configuration . Installation roadmap Perform these actions to install and configure the disk array: 1. Installing and configuring the disk array • Setting the host mode and host group mode • Setting the System Option Modes • Configuring the Fibre Channel ports 2. Install and configure the host • Loading the operating system and software • Installing and configuring the FCSAs • Fabric zoning and LUN security 3. Connect the disk array • Defining the paths • Verifying disk array device recognition 4. Configure disk devices Installing and configuring the disk array The HP service representative performs these tasks: • Assembling hardware and installing software • Loading the microcode updates • Installing and formatting devices After these tasks are finished, you will use XP Remote Web Console, XP Command View Advanced Edition Software, or XP Array Manager to complete the remaining tasks listed below. If you do not have these programs, your HP service representative can perform these tasks for you. XP Disk Array Configuration Guide for NonStop 9