HP StoreOnce 4420 HP D2D Backup System Installation and Configuration guide (E - Page 6
Before you start, Introduction, What is the HP StoreOnce Backup System?
View all HP StoreOnce 4420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2 Before you start In this chapter: • Introduction (page 6) • What is the HP StoreOnce Backup System? (page 6) • Software and hardware requirements (page 6) • Supported Ethernet configurations (page 7) • Supported Fibre Channel connections (page 7) • Web browser settings (page 8) Introduction This guide describes how to install and carry out the initial configuration of your HP StoreOnce Backup System. The following documents are also available at http://www.hp.com/support/ manuals: • HP StoreOnce Backup System Concepts Guide: If you are new to the HP StoreOnce Backup System, it is a good idea to read this guide before you configure your system. It describes the StoreOnce technology. • HP StoreOnce Backup System User Guide: This guide contains detailed information on using the Web Management Interface. It also contains troubleshooting information, including details on replacing failed or failing hard disks. • D2D Best Practices for VTL, NAS and Replication implementations: This white paper advises how to plan the workload being placed on the HP StoreOnce Backup System in order to optimize performance and minimize the impact of deduplication, replication and housekeeping operations competing for resources. It is regularly updated. What is the HP StoreOnce Backup System? The HP StoreOnce Backup System is a disk-based storage appliance for backing up host network servers or PCs to target devices on the appliance. These devices are configured as either Network-Attached Storage (NAS) or Virtual Tape Library (VTL) targets for backup applications. The total number of backup targets provided by an HP StoreOnce Backup System is split between VTL and NAS devices. These devices may be all VTL, all NAS or any combination of NAS and VTL devices. All HP StoreOnce devices that are configured for NAS or VTL automatically make use of HP deduplication, ensuring efficient and cost-effective use of disk space. See the HP StoreOnce Backup System Concepts Guide for a more detailed discussion about VTL and NAS. Software and hardware requirements Refer to http://www.hp.com/go/connect or http://www.hp.com/go/ebs for the latest connectivity and compatibility information. • All HP StoreOnce Backup Systems must be connected to a 1Gb Ethernet network for installation and discovery. • HP D2D2500 Series and D2D4100 Series models should be connected to a 1Gb network for all backup and replication activities. 100 Base-T Ethernet will limit performance; 10 Base-T Ethernet will severely limit performance. 6 Before you start