HP StoreOnce D2D4324 HP StorageWorks Linux and UNIX configuration guide for D2 - Page 27
HP-UX 11i V2/V3 (PA-RISC & IA64), Overview, Configuring the HP D2D Backup System for iSCSI, How
View all HP StoreOnce D2D4324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
4 HP-UX 11i V2/V3 (PA-RISC & IA64) Overview This chapter describes how to configure the HP D2D Backup System for use with the following HP-UX operating systems: • HP-UX 11i V2 (PA-RISC and IA64) • HP-UX 11i V3 (PA-RISC and IA64) NOTE: A block size no larger than 256 KB is strongly recommended when working with HP-UX 11i V2. See "Using large block sizes with HP-UX 11i V2" on page 38. Configuring the HP D2D Backup System for iSCSI How to install the iSCSI software initiator The iSCSI Software Initiator is located at the HP Software Depot. 1. Go to http://www.software.hp.com. 2. Enter iSCSI Software Initiator in the search box. 3. When the search results show iSCSI Software Initiator, click on Receive for Free. 4. In the Software Specification window, highlight the HP-UX version on which you want to install the HP-UX iSCSI Software Initiatot.Then complete the required fields and click on Next >> 5. Look for Download Software, then click on the iSCSI Software Initiator version that you would like to download. 6. In the Document column (next to the Download Software column), click on Installation Instruction to download instructions for using the Software Distributor tool to install the iSCSI Software Initiator. NOTE: The Software Distributor is used for software installations on HP-UX systems. It also provides an interface for removing software from HP-UX systems. D2D Backup System 27