HP Surestore 330fx Capacity Upgrade For C1104/05 Series Jukeboxes - C1159-9000 - Page 13

Install the old SCSI interface PCA in the new interface module.

Get HP Surestore 330fx - Optical Jukebox PDF manuals and user guides View all HP Surestore 330fx manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

5. Attach the power cables. Refer to Figure 10 for proper power cable connections. Figure 10: Paths for connection of power cables a. Connect the interposer PCA power cable. 1. Connect the 2 connectors on the power cable to the lower interposer PCA (at the upper and middle power connectors on the right side of the interposer PCA). 2. Route this cable to the new power supply along the path indicated in Figure 10. Use the stake-in clamps along the path. b. Connect the interposer PCA power cable connectors to the connectors on the top of the new power supply as shown in the detail of Figure 10. c. Attach the short AC power cable to the bottom of the new power supply and to the power distributor PCA as shown in Figure 10. 3. Install the "old" SCSI interface PCA in the new interface module. a. Mount the SCSI PCA you removed from the previous module into the new enclosure. Use the 6, 1/4-inch hex standoff screws from the upgrade kit. See Figure 11. b. Install the new SCSI PCA on top of the first PCA. Mount its screws into the hex standoffs. Use the T-15 screws that were previously installed. Add a jumper to the left-most position of the jumper block shown in Figure 12. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
13
5.
Attach the power cables. Refer to Figure 10 for proper power cable connections.
Figure 10: Paths for connection of power cables
a.
Connect the interposer PCA power cable.
1.
Connect the 2 connectors on the power cable to the lower interposer PCA (at the
upper
and middle power connectors on the right side of the interposer PCA).
2.
Route this cable to the new power supply along the path indicated in Figure 10.
Use the stake-in clamps along the path.
b.
Connect the interposer PCA power cable connectors to the connectors on the top of the new
power supply as shown in the detail of Figure 10.
c.
Attach the short AC power cable to the bottom of the new power supply and to the power
distributor PCA as shown in Figure 10.
3.
Install the "old" SCSI interface PCA in the new interface module.
a.
Mount the SCSI PCA you removed from the previous module into the new enclosure. Use
the 6, 1/4-inch
hex standoff screws from the upgrade kit. See Figure 11.
b.
Install the new SCSI PCA on top of the first PCA. Mount its screws into the hex standoffs.
Use the T-15 screws that were previously installed.
Add a jumper to the left-most position
of the jumper block shown in Figure 12
.