HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director Power Cord Advisory Read - Page 2
Director 2/140 Power Cord Requirements
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Director 2/140 Power Cord Requirements Director 2/140 Power Cord Requirements The Director 2/140 includes two power supplies (labeled PS0 and PS1 on the rear of the unit) for redundancy. You must connect each power supply to an appropriate power source that provides 220-volt AC power. Connect each Director 2/140 power supply to a power distribution unit receptacle using a PDU power cord. Note: To ensure redundancy, install an second optional PDU and connect each PDU power cord to a separate PDU. Director 2/64 Power Cord Requirements The Director 2/64 includes two power supplies (labeled PS0 and PS1 on the rear of the unit) for redundancy. Each power supply must be connected to an appropriate power source that provides 110-volt or 220-volt AC power. Connect the Director 2/64 to a power source using one of the following methods: ■ Connect each power supply to a 110-volt receptacle using a 110-volt AC power cord. ■ Connect each power supply to a power distribution unit using a PDU power cord. Note: To ensure redundancy, connect each AC power cord to a separate facility power source or PDU. WARNING: To prevent electric shock when connecting the Director to primary facility power, use only the supplied power cord(s), and ensure the facility power receptacle is the correct type, supplies the required voltage, and is properly grounded. 2 Read Me First - HP StorageWorks Director Power Cord Advisory