HP Surestore S10 Service and User Manual (Short- and Long-Wave) - Page 75
If the Hub Fault LED Stays on After Self-Test
View all HP Surestore S10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
If the Hub Fault LED Stays on After Self-Test If the hub Fault LED stays on after the self-test is complete, find the symptom that best describes the situation, then attempt the solution. When more than one solution is possible, the most likely one is listed first. Symptom Cause/Solution The host can access devices, but the hub Fault LED stays on after self-test. - One or more fans are faulty. Replace the fan module. Although the module will continue to run with two fans, a full complement of fans ensures system and data integrity. - The hub is experiencing an internal temperature or memory fault. Replace the hub. The host cannot access devices, and the Fault LED stays on after self-test. - The hub is faulty. Replace the hub. Troubleshooting If the Hub Fault LED Stays on After Self-Test 73