HP T1500 IEC-320-C14 HP UPS Network Module Installation Instructions - Page 1
HP T1500 IEC-320-C14 Manual
View all HP T1500 IEC-320-C14 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP UPS Network Module Installation Instructions Translated instructions For translated instructions, see the documentation provided on the HP website (http://www.hp.com/support/HPNM_Manuals). Front panel connectors and LED indicators 2. Install the UPS Network Module along the alignment channels in the option slot. © Copyright 2010 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Microsoft® and Windows® are U.S. registered trademarks of Microsoft Corporation. Part Number 637917-001 December 2010 (First Edition) *637917-001* 637917-001 (http://www.hp.com/support/HPNM_Manuals) Overview The HP UPS Network Module enables you to monitor, manage, and control power environments for multiple devices over the network connection. The UPS Network Module can send email notifications to configured recipients and alert traps to specified SNMP management programs, such as HP Systems Insight Manager, or used as a standalone management system. For more information about any of the topics covered in this document, including safety and regulatory notices, see the HP UPS Network Module User Guide located on the HP website (http://www.hp.com/support/HPNM_Manuals). For a detailed list of supported UPSs, see the HP website (http://www.hp.com/go/rackandpower). Precautions See the Important Safety Information guide (included in the UPS kit) before installing this product. WARNING: A risk of personal injury from electric shock and hazardous energy levels exists. The installation of options and routine maintenance and service of this product must be performed by individuals who are knowledgeable about the procedures, precautions, and hazards associated with AC power products. Kit contents • This document • Warranty information • UPS Network Module (product number AF465A) • DB-9 to RJ-45 cable To download the latest version of UPS Network Module firmware, see the HP website (http://www.hp.com/go/rackandpower). Required tools No. 2 Phillips screwdriver Item Connector/LED Description 1 Network connector Ethernet port 2 Network Activity • Off-UPS Network Module not LED connected to the network • Solid green-UPS Network Module connected to the network, but no activity detected • Flashing green-UPS Network Module connected to the network and sending or receiving data 3 Network Speed • Off-Port operating at 10 Mb/s LED • Solid orange-Port operating at 100 Mb/s 4 Settings/AUX Configuration port connector 5 UPS Data LED • Off-UPS Network Module starting • Solid green-UPS Network Module communicating with UPS • Flashing green-Normal operation (communication link established) 6 Configuration • Off-Configuration menu activated Menu LED • Solid orange-Normal operation (Configuration menu not activated) Installing the UPS Network Module NOTE: It is not necessary to power down the UPS before installing the UPS Network Module. 1. Remove the two screws securing the UPS option slot cover plate and slide the plate out. 3. If the UPS is powered up, you can be sure that the UPS Network Module is seated properly and communicating with the UPS by verifying that the UPS Data LED illuminates solid green, and then flashes regularly after 2 minutes. 4. Secure the UPS Network Module using the two screws you removed in step 1. Connecting the network cable Connect a standard Ethernet cable between the network connector on the UPS Network Module and a network jack.