HP Visualize c240se hp workstations - hp-ux 10.20 graphics administration guid - Page 119
Why Is Gamma Correction Needed?, gamma, Brightness
View all HP Visualize c240se manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Why Is Gamma Correction Needed? The intensity of light generated by a conventional monitor is non-linear with respect to the signal applied. The intensity output is approximately equal to the applied voltage raised to a power. This power is referred to as the gamma of the monitor. Stated mathematically, intensity = voltagegamma For example, the gamma value of a properly adjusted monitor is usually between 2.35 and 2.55. Ideally, to produce an image that is 50% intensity, you would specify color values that are 50% of the maximum value. However, a monitor with a gamma of 2.4 would generate an intensity that is only 19% of the maximum intensity (0.5 2.4 = 0.19). The intensity principle is illustrated in the following test patterns. The pattern on the left has an area with exactly 50% brightness directly next to an area of horizontal stripes that alternate 100% brightness with 0% brightness. From a distance, the intensity of each area should be about the same. The middle pattern is basically the same, but just a little dimmer. Figure 13: Brightness Once the brightness and contrast of your monitor are adjusted properly (see below), you can run the gamma correction tool (also described below) to see its effect on the test patterns above. Page 119 Graphics Administration Guide for HP-UX 10.20