HP Visualize c3000 hp Visualize b1000, c3000, c3600 workstations service handb - Page 130

Field Replaceable Units FRU Removal and Replacement 2. Remove the floppy rear disk cover by unscrewing the T-15 Torx screw as shown in Figure 4-42. Note that the floppy's rear cover is located on the rear of the removable media chassis inside the system unit. Push the cover handle away from the rear of the removable media chassis approximately one inch. Next pull the cover handle toward you. Remove the data and power cables from their connectors. Figure 4-42. Removing the Floppy Disk's Rear Cover T-15 Torx/slotted Screw Power Cable Data Cable Floppy Rear Cover 3. Rotate the workstation around until you can see the front of the unit as shown in Figure 4-43.. Figure 4-43. Front of Workstation with the Front Panel Removed LCD Power Switch Floppy Disk Drive Bracket Screw Bracket Screw (hidden) 4. Remove both floppy disk bracket screws (T-15 torx screws) and pull the floppy disk drive out of the chassis assembly as shown in Figure 4-43. Next remove the four floppy disk mounting screws (T-10 torx screws) as shown in Figure 4-44 and remove the floppy disk drive from the bracket. You are now ready to attach the floppy disk drive blank to the floppy disk bracket. 130 Chapter 4