HP Workstation zx2000 ATI Fire GL X1 and Z1 Graphics Cards - Read Before Insta
HP Workstation zx2000 Manual
View all HP Workstation zx2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Workstation zx2000 manual content summary:
- HP Workstation zx2000 | ATI Fire GL X1 and Z1 Graphics Cards - Read Before Insta - Page 1
) before installing the new graphics card. The latest firmware or BIOS can be downloaded from www.hp.com/go/bizsupport. ■ Refer to the Technical Reference or Operations And Maintenance Guides for your specific workstation model for comprehensive instructions on adding or replacing a graphics card - HP Workstation zx2000 | ATI Fire GL X1 and Z1 Graphics Cards - Read Before Insta - Page 2
plate on the rear of the workstation. HP offers additional graphics information on www.hp.com/go/bizsupport. For other information on ATI graphics products, visit www.ati.com. 7. Refer to the Technical Reference or Operations And Maintenance Guides for instructions on how to verify your graphics - HP Workstation zx2000 | ATI Fire GL X1 and Z1 Graphics Cards - Read Before Insta - Page 3
. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference - HP Workstation zx2000 | ATI Fire GL X1 and Z1 Graphics Cards - Read Before Insta - Page 4
Declaration of Conformity according to ISO/IEC Guide 22 and EN 45014 Manufacturer: Hewlett-Packard in a typical Hewlett-Packard workstation configuration. For Compliance Information ONLY, contact: European Contact: Your local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH,
read before installing
ATI™ FIRE GL™ X1 and Z1
graphics cards
before you begin
Before you install your new graphics card, please do the following:
Ä
CAUTION:
When handling your card always wear a properly grounded wrist strap and handle
the card carefully since it is susceptible to electrostatic shock.
■
Refer to the
Technical Reference
or
Operations And Maintenance Guides
for your workstation model at
www.hp.com/go/bizsupport
for the latest important system configuration information.
■
Install the latest firmware (for Itanium2 workstations) or latest BIOS (for Pentium/Xeon-based workstations)
before installing the new graphics card. The latest firmware or BIOS can be downloaded from
www.hp.com/go/bizsupport
.
■
Refer to the
Technical Reference
or
Operations And Maintenance Guides
for your specific workstation model
for comprehensive instructions on adding or replacing a graphics card.
■
Uninstall the current graphics driver (if you are installing this card on a system that currently has a different
graphics card).
general HP installation instructions
To install the graphics card:
1.
Disconnect all cables from your workstation.
2.
Remove the bulkhead or existing graphics card.
3.
Following the procedures described in the
Technical Reference or Operations And Maintenance Guides
, slide
the graphics board into the AGP Pro slot
1
and secure it with the two screws. (Some systems may have the
AGP Pro down on the system board or it may reside in a card cage.) Ensure the board is fully seated in the
connector.