HP Workstation zx2000 HP Release Notes for HP OpenGL for HP-UX 11.X of IPF-Bas - Page 1

Release Notes for HP OpenGL for HP-UX 11.23 (June 2003) on IPF-Based Systems Note: These release notes are cumulative and contain information about the HPUX 11.23 Operating Environment June 2003 release. For additional information about HP's implementation of OpenGL, go to http://www.hp.com/support/workstation_manuals. 1. ANNOUNCEMENTS N/A 2. WHAT'S IN THIS VERSION? Support of new devices: ATI FireGL X1 and FireGL Z1 Note: 2D/3D Distributed Single Logical Screen (SLS/d) for OpenGL is not supported with this release. See the following documentation for additional information: * The "Addenda -- Additional Graphics Information" section of this document * OpenGL Implementation Guide * Graphics Administration Guide * OpenGL and Common Graphics Release Notes located in /opt/graphics/common/ReleaseNotes These documents can also be viewed at http://www.hp.com/support/workstation_manuals. 3. KNOWN PROBLEMS AND WORKAROUNDS N/A 4. COMPATIBILITY AND INSTALLATION REQUIREMENTS Software Requirements The version of OpenGL shipped with the HP-UX 11.23 Operating Environment June 2003 release requires the use of the HP-UX 11.23 Operating Environment June 2003 release or later. Hardware Requirements For detailed information about supported graphics configurations (HP-UX computers combined with bit-mapped graphics devices) consult the Graphics Administration Guide. Disk Space Requirements Use the "swinstall" command to determine the necessary and available disk space for the 3D graphics application programming interface (API) you wish to install.