HP XM600 hp kayak pc workstations, using sound - Page 30
Windows 3.11 and MS-DOS System File Settings, Environment Variables
View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Using Sound on Your PC Windows 3.11 and MS-DOS System File Settings Windows 3.11 and MS-DOS System File Settings The following descriptions are valid only if you are running the Windows 3.11 or MS-DOS operating systems on your computer. Environment Variables Your AUTOEXEC.BAT file contains three environment variables for the sound board: SOUND, BLASTER, and GALAXY. To modify these variables, refer to "Viewing the Software Settings Under Windows 3.11" on page 29. SOUND Environment The SOUND environment variable specifies the directory location of your sound Variable board's drivers and software. The command for setting this variable is: SET SOUND=path where path is the drive and directory of your sound board's software (for example, C:\MMP16VA). BLASTER The BLASTER environment variable specifies the configuration of your sound Environment Variable blaster compatible audio interface. The command for setting this variable is: SET BLASTER=A220 I5 D1 T4 Note that there is no space before or after the equal sign, but there is a space between two settings. The parameter settings are shown below. Parameter Axxx Ix Dx T4 Description Specifies the audio interface's base I/O address. xxx can be 220 or 240. Specifies the interrupt request line used by the audio interface. x can be IRQ 5, 9, 10, or 11. Specifies the Low DMA channel used by the audio interface. x can be 0, 1 or 3. Specifies the board type (4 means Sound Blaster Pro). 30 English