HP XP1024 HP StorageWorks Disk Array XP operating system configuration guide: - Page 13

Install and con, gure the disk array

Get HP XP1024 PDF manuals and user guides View all HP XP1024 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Install and configure the disk array The HP service representative performs these tasks: • Assembling hardware and installing software • Loading the microcode updates • Installing and formatting devices After these tasks are finished, you will use Remote Web Console XP, Command View XP, Command View XP Advanced Edition, or LUN Configuration and Security Manager XP to complete the remaining tasks listed below. If you do not have these programs, your HP service representative can perform these tasks for you. Setting the System Option Modes The NonStop servers have no operating system specific System Option Mode requirements. Configuring the Fibre Channel ports Configure the disk array Fibre Channel ports by using Remote Web Console XP (shown), Command View XP, or Command View XP Advanced Edition. Select the settings for each port based on your storage area network topology. Use switch zoning if you connect different types of hosts to the array through the same switch. HP StorageWorks Disk Array XP operating system configuration guide NonStop 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
Install and con
fi
gure the disk array
The HP service representative performs these tasks:
•
Assembling hardware and installing software
•
Loading the microcode updates
•
Installing and formatting devices
After these tasks are
fi
nished, you will use Remote Web Console XP, Command View XP,
Command View XP Advanced Edition, or LUN Con
fi
guration and Security Manager XP
to complete the remaining tasks listed below. If you do not have these programs, your
HP service representative can perform these tasks for you.
Setting the System Option Modes
The NonStop servers have no operating system speci
fi
c System Option Mode
requirements.
Con
fi
guring the Fibre Channel ports
Con
fi
gure the disk array Fibre Channel ports by using Remote Web Console XP (shown),
Command View XP, or Command View XP Advanced Edition. Select the settings for
each port based on your storage area network topology. Use switch zoning if you
connect different types of hosts to the array through the same switch.
HP StorageWorks Disk Array XP operating system con
fi
guration guide NonStop
13