HP XP1024 HP StorageWorks Disk Array XP operating system configuration guide: - Page 13

Install and con, gure the disk array

Get HP XP1024 PDF manuals and user guides View all HP XP1024 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Install and configure the disk array The HP service representative performs these tasks: • Assembling hardware and installing software • Loading the microcode updates • Installing and formatting devices After these tasks are finished, you will use Remote Web Console, Command View, Command View XP Advanced Edition, or LUN Configuration and Security Manager to complete the remaining tasks listed below. If you do not have these programs, your HP service representative can perform these tasks for you. Setting the host mode for the disk array ports After the disk array is installed, you must set the host mode for each disk array port to match the host OS. Set the host mode using LUN Manager in Remote Web Console XP (shown), Command View XP, or Command View XP Advanced Edition. If these are not available, the HP representative can set the host mode using the SVP. The host mode setting for Solaris is 09. Disk Array XP operating system configuration guide: Sun Solaris 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
Install and con
fi
gure the disk array
The HP service representative performs these tasks:
•
Assembling hardware and installing software
•
Loading the microcode updates
•
Installing and formatting devices
After these tasks are
fi
nished, you will use Remote Web Console, Command View,
Command View XP Advanced Edition, or LUN Con
fi
guration and Security Manager to
complete the remaining tasks listed below. If you do not have these programs, your HP
service representative can perform these tasks for you.
Setting the host mode for the disk array ports
After the disk array is installed, you must set the host mode for each disk array port to
match the host OS. Set the host mode using LUN Manager in Remote Web Console
XP (shown), Command View XP, or Command View XP Advanced Edition. If these are
not available, the HP representative can set the host mode using the SVP. The host
mode setting for Solaris is
09
.
Disk Array XP operating system con
fi
guration guide: Sun Solaris
13