HP Xw4600 HP xw and Z Series Workstations - HP SATA/SAS Hard Drive and Solid S - Page 6
Step 3—Configuring the cabling, HP Z200 and Z400 Workstations and HP xw Workstations
![]() |
UPC - 883585516483
View all HP Xw4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
4. Slide the drive carrier firmly into the hard drive bay, rotating the handle to snap it closed. 5. Continue to Step 3-Configuring the cabling on page 6 Step 3-Configuring the cabling HP Z200 and Z400 Workstations and HP xw Workstations NOTE: HP Z200 Workstations do not support SAS hard drives. 1. If installing a SAS hard drive, attach the SAS-to-SATA interconnect cable adapter to the SAS connector on the hard drive. The cable adapter is provided with the kit and is required only when installing a SAS hard drive. Figure 5 Install the SAS-to-SATA adapter 2. Select the SATA interconnect cable from the kit that best fits the hardware configuration of your SATA or SAS hard drive. A cable with a right-angle connector can be used to avoid bending or crushing the cable. NOTE: Individual SATA ports and connectors on the system board are identified on the service label, located inside the computer side access panel. 6 HP SATA/SAS hard drive and Solid State Drive installation ENWW
![](/manual_guide/products/hewlettpackard-xw4600-hp-xw-z-series-workstations-hp-satasas-hard-drive-solid-state-drive-installation-a613f14/6.png)