HP Xw460c Processor Option Installation Instructions for HP ProLiant BL460c Se
HP Xw460c - ProLiant - Blade Workstation Manual
 |
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Xw460c manual content summary:
- HP Xw460c | Processor Option Installation Instructions for HP ProLiant BL460c Se - Page 1
Processor Option Installation Instructions for HP ProLiant BL460c Server Blades © Copyright 2006 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty - HP Xw460c | Processor Option Installation Instructions for HP ProLiant BL460c Se - Page 2
has either four or five thumbscrews. For specific steps, see the server blade user guide on the HP website (http://www.hp.com/go/bladesystem/documentation) . 5. Remove the hard drive backplane. 8. Open the processor retaining latch and the processor socket retaining bracket. 9. Remove the - HP Xw460c | Processor Option Installation Instructions for HP ProLiant BL460c Se - Page 3
screws should be tightened in diagonally opposite pairs (in an "X" pattern). 15. Install the heatsink. 13. Close the processor socket retaining bracket and the processor retaining latch. 16. Install the front panel/hard drive cage assembly. 17. Install the hard drive backplane. 18. Install
-
1 -
2 -
3
 |
 |
Processor Option
Installation Instructions
for HP ProLiant BL460c Server Blades
© Copyright 2006 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
May 2006 (First Edition)
Part Number 410958-001
Kit contents
•
Processor with installation tool
•
Heatsink
•
This document
Installing a processor
WARNING:
To reduce the risk of personal
injury from hot surfaces, allow the drives
and the internal system components to cool
before touching them.
CAUTION:
To avoid damage to the system board:
•
Do not touch the socket contacts.
•
Always install the processor socket cover after
removing the processor from the socket.
•
Do not tilt or slide the processor when lowering
the processor into the socket.
CAUTION:
To avoid damage to the processor:
•
Handle the processor only by the edges.
•
Do not touch the bottom of the processor,
especially the contact area.
CAUTION:
To prevent possible server malfunction
and damage to the equipment, multiprocessor
configurations must contain processors with the
same part number.
CAUTION:
To prevent possible server blade
overheating, always populate processor socket 2
with a processor and a heatsink or a processor
cover and a heatsink blank.
CAUTION:
The heatsink thermal interface media is
not reusable and must be replaced if the heatsink is
removed from the processor after it has been
installed.
IMPORTANT:
When installing the heatsink, align
the guide pins on the processor retention bracket
with the alignment holes in the heatsink.
IMPORTANT:
Processor socket 1 must always be
populated. If processor socket 1 is empty, the server
blade does not power up.
NOTE:
Do not discard the processor protective
cover. Always install the processor protective cover
if the processor is removed from the socket.
1.
Power down the server blade.
2.
Remove the server blade.
3.
Remove the access panel.
4.
Remove all hard drives and hard drive blanks.