HP Xw6600 HP xw Workstation series - HP eSATA PCI cable kit installation - Page 5

If only one SATA port is available or if you are using only one eSATA device, you can

Page 5 highlights

2. Insert the eSATA adapter into the PCI slot, with the two SATA connector cables protruding inside the workstation chassis (1), and close the PCI retainer (2) to its locked position (as shown in the following two figures). Figure 2 Installing the eSATA adapter (HP xw8600 Workstation) 3. Connect the two eSATA adapter cables to SATA ports SATA4 and SATA5 (the two red colored SATA connectors) on the workstation system board (as shown in the previous and the following figure). NOTE: If only one SATA port is available or if you are using only one eSATA device, you can connect only a single eSATA adapter cable and secure the unused cable so that it does not interfere with operation of other components within the chassis. Figure 3 Connecting the eSATA adapter cables to the system board (HP xw6600 Workstation) ENWW Step 2-Installing the eSATA adapter 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

2.
Insert the eSATA adapter into the PCI slot, with the two SATA connector cables protruding inside
the workstation chassis (1), and close the PCI retainer (2) to its locked position (as shown in the
following two figures).
Figure 2
Installing the eSATA adapter (HP xw8600 Workstation)
3.
Connect the two eSATA adapter cables to SATA ports SATA4 and SATA5 (the two red colored
SATA connectors) on the workstation system board (as shown in the previous and the following
figure).
NOTE:
If only one SATA port is available or if you are using only one eSATA device, you can
connect only a single eSATA adapter cable and secure the unused cable so that it does not interfere
with operation of other components within the chassis.
Figure 3
Connecting the eSATA adapter cables to the system board (HP xw6600 Workstation)
ENWW
Step 2—Installing the eSATA adapter
5