HP Xw8200 Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw - Page 57
Check that both power, supply cables are properly
UPC - 882780210455
View all HP Xw8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Troubleshooting Activity System does not power on and LEDs are not blinking. Beeps None Possible Cause System unable to power on. Recommended Action Press and hold the power button for less than 4 seconds. If the hard drive LED turns green, then: 1. Remove the expansion cards one at a time until the 5.5 V_aux light on the system board turns on. 2. Replace the system board. OR Press and hold the power button for less than 4 seconds. If the hard drive LED does not turn on green then: 1. Check that unit is plugged into a working AC outlet. 2. Open hood and check that the power button harness is properly connected to the system board. 3. Check that both power supply cables are properly connected to the system board. 4. Check to see if the 5.5 V_aux light on the system board is turned on. If it is turned on, then replace the power button harness. 5. If the 5.5 V_aux light on the system board is not turned on, then replace the power supply. 6. Replace the system board. Getting Started Guide www.hp.com 4-23