HP Xw8400 SAS Rear Panel Cable

of 2

SAS Rear Panel Cable Installation

SAS Rear Panel Cable

HP xw Series Workstations

This document describes how to install the Serial Attached SCSI (SAS) rear panel cable for your HP

Workstation.

Kit Contents

This kit includes the following components:

■

SAS rear panel cable with mounting screw

■

SAS rear panel cable instruction (this document)

■

Warranty

Observe Warnings and Cautions

Å

WARNING:

Any surface or area of the equipment marked with this symbol indicates the presences of a

hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of

injury from a hot component, allow the surface to cool before touching.

Å

WARNING:

Any surface or area of the equipment marked with this symbol indicates the presence of an

electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area.

Ä

CAUTION:

Static electricity can damage the electronic components of the workstation. Before beginning

these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal

object.

Step 1—Prepare the Workstation

Your workstation documentation includes instructions for disassembling and preparing the workstation for

installation, including shutting down power, disconnecting all power from the system, and removing the

access panel. For more detailed information, refer to the

Service and Technical Reference Guide

for your

HP Workstation at

http://www.hp.com/support/workstation_manuals

.

Section	Page
Kit Contents	1
Observe Warnings and Cautions	1
Step 1-Prepare the Workstation	1
Step 2-Install the SAS Rear Panel Cable	2

HP Xw8400 SAS Rear Panel Cable

HP Xw8400 - Workstation - 4 GB RAM Manual

HP Xw8400 manual content summary: