HP Xw8400 SAS Rear Panel Cable - Page 1
HP Xw8400 - Workstation - 4 GB RAM Manual
UPC - 883585271085
View all HP Xw8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
SAS Rear Panel Cable Installation SAS Rear Panel Cable HP xw Series Workstations This document describes how to install the Serial Attached SCSI (SAS) rear panel cable for your HP Workstation. Kit Contents This kit includes the following components: ■ SAS rear panel cable with mounting screw ■ SAS rear panel cable instruction (this document) ■ Warranty Observe Warnings and Cautions Å WARNING: Any surface or area of the equipment marked with this symbol indicates the presences of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of injury from a hot component, allow the surface to cool before touching. Å WARNING: Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area. Ä CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal object. Step 1-Prepare the Workstation Your workstation documentation includes instructions for disassembling and preparing the workstation for installation, including shutting down power, disconnecting all power from the system, and removing the access panel. For more detailed information, refer to the Service and Technical Reference Guide for your HP Workstation at http://www.hp.com/support/workstation_manuals. Page 1 of 2