HP Xw8400 SAS Rear Panel Cable
HP Xw8400 - Workstation - 4 GB RAM Manual
 |
UPC - 883585271085
View all HP Xw8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Xw8400 manual content summary:
- HP Xw8400 | SAS Rear Panel Cable - Page 1
includes instructions for disassembling and preparing the workstation for installation, including shutting down power, disconnecting all power from the system, and removing the access panel. For more detailed information, refer to the Service and Technical Reference Guide for your HP Workstation at - HP Xw8400 | SAS Rear Panel Cable - Page 2
panel cables to the SAS connectors; otherwise, the hard drives will not function. Locate the SAS connectors by reviewing the system board layout illustration on the access panel. Use the following illustration only as an example, not as a guide to connector location. 1. Attach the SAS cables of the - HP Xw8400 | SAS Rear Panel Cable - Page 3
SAS SAS HP xw Series Workstation HP Workstation SAS(Serial Attached SCSI SAS SAS 手順 1 http://www.hp.com/support/workstation_manuals HP Service and Technical Reference Guide 3/4 - HP Xw8400 | SAS Rear Panel Cable - Page 4
SAS 手順 2 － SAS SAS Ä 注意 : SAS SATA SAS SAS SAS SAS 1. SAS SAS SAS 1 SAS 4 2 2 SAS MiniSAS 4X 1 2 手順 3 SAS 416482-001 ©2006 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P. 4/4
-
1 -
2 -
3 -
4
 |
 |
1/4
SAS Rear Panel Cable Installation
SAS Rear Panel Cable
HP xw Series Workstations
This document describes how to install the Serial Attached SCSI (SAS) rear panel cable for your HP
Workstation.
Kit Contents
This kit includes the following components:
■
SAS rear panel cable with mounting screw
■
SAS rear panel cable instruction (this document)
■
Warranty
Observe Warnings and Cautions
Å
WARNING:
Any surface or area of the equipment marked with this symbol indicates the presences of a hot
surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of
injury from a hot component, allow the surface to cool before touching.
Å
WARNING:
Any surface or area of the equipment marked with this symbol indicates the presence of an
electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area.
Ä
CAUTION:
Static electricity can damage the electronic components of the workstation. Before beginning
these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal
object.
Step 1—Prepare the Workstation
Your workstation documentation includes instructions for disassembling and preparing the workstation for
installation, including shutting down power, disconnecting all power from the system, and removing the
access panel. For more detailed information, refer to the
Service and Technical Reference Guide
for your
HP Workstation at
.