HP Z3100 HP Designjet Z3100 Printing Guide [HP Raster Driver] - Add and profil - Page 7

The printer will calibrate itself for use with your paper. The process takes about 10 minutes and consists of the following steps: • A calibration test chart is printed. • The test chart is allowed to dry for a period of time, the amount of time depends on the paper type, this is so the colors have time to stabilize. • The test chart is scanned and measured using the HP Embedded Spectrophotometer. Create and Install ICC Profile > Once the printer calibration is complete, load again your new paper into the printer (A3/B size). The following message will be displayed prompting for paper if it is not loaded: When you have defined and calibrated a new paper type, the printer automatically creates and installs the new ICC profile, this is to be used with your paper. The process takes about 15-20 minutes and consists of the following steps: 1. A profiling test chart is printed: An A3 or B format for cut sheets: A roll-paper format for roll: 2. The test chart is allowed to dry for a period of time; the amount of time depends on the paper type. 3. The test chart is scanned and measured using the HP Embedded Spectrophotometer. 7