HP Z600 HP Workstations for Linux - User Guide - Page 29
LSI WebBIOS - Adapter selection, LSI WebBIOS - Main screen
UPC - 884962074053
View all HP Z600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Use the following steps as a guide to set up the LSI 8344ELP or the LSI 8888ELP or SAS RAID. Details will vary based on the specific configuration used. 1. Boot the workstation, and when prompted, press CTRL-H to enter LSI's WebBIOS utility. WebBIOS will be run after POST completes. Select the desired adapter from the Adapter Selection screen and press start to enter the utility. Figure 6-8 LSI WebBIOS - Adapter selection 2. The main WebBIOS screen can be used to configure the adapter, the physical disks, and the virtual disks or RAID arrays. The first view shows the physical disks connected to the adapter, any RAID arrays presently configured, as well as the status of both physical and virtual disks. Figure 6-9 LSI WebBIOS - Main screen ENWW LSI 8344ELP and LSI 8888ELP Setup 25