HP Z800 HP Z800 Workstation - HP 2.5-inch Hard Drive 2:1 Optical Bay Bracket I - Page 3
Step 1—Preparing for component installation, Accessing the internal components of the workstation
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Step 1-Preparing for component installation NOTE: Workstation models vary. All illustrations are examples only. Accessing the internal components of the workstation 1. If you need help preparing the workstation for this installation, consult the removal and replacement procedures in the service guide for your workstation at http://www.hp.com/support/ workstation_manuals. NOTE: For the HP Workstation series, these procedures are also available in the User Guide on the Documentation and Diagnostics CD that shipped with your workstation. 2. Power down the workstation, and then disconnect the power cord. 3. Power down all external devices, and then disconnect them from the workstation. 4. Remove the side access panel. Removing components 1. If installing in an HP 800 Workstation, remove the airflow guide to enable access to the optical bays. 2. If present, remove the card support to enable access to the system board connectors. 3. Remove the front bezel if applicable. NOTE: The front bezel does not need to be removed on HP 600 and HP 800 Workstations. 4. Remove the filler from the lowest available optical drive bay. ENWW Step 1-Preparing for component installation 3