HP dx6120 HP ProtectTools Embedded Security Guide - Page 24
Reset to Factory, Embedded Security Device-Disable
View all HP dx6120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
HP ProtectTools Embedded Security ✎ If you do not press the F10 key at the appropriate time, you must restart the computer and press and hold the F10 key again to access the utility. If you are using a PS/2 keyboard, you may see a Keyboard Error message-disregard it. 3. If necessary, enter the setup password and press Enter. 4. Use the up or down arrow key to select the language. Press Enter to enter Computer Setup. For navigation instructions, press F1. 5. If the Security setup password has not been set, one must be set now. Use the left or right arrow key to select the Security menu, then use the up or down arrow key to select Setup Password. Press Enter, enter and confirm a new setup password, and press F10 to accept. ✎ Type carefully; for security reasons, the characters typed do not appear on the screen. 6. In the Security menu, use the up or down arrow key to select Embedded Security Device, then press Enter. 7. If only one selection, Embedded Security Device-Disable, is available, go to step 13. 8. If two selections are available: a. Use the up or down arrow key to move to Reset to Factory Settings-Do Not Reset. Press the left or right arrow key once. A message is displayed stating: Performing this action will erase all security keys. Data loss may occur. Press any key to continue. b. Press Enter. The selection will now read Reset to Factory Settings-Reset. 9. Press F10 to accept the change. 20 www.hp.com HP ProtectTools Embedded Security Guide