Home » HP Manuals » Desktops » HP j6700 » Manual Viewer

HP j6700 hp workstations - HP A7789A Fire GL UX Graphics Card And Software - Page 4

j6700/j6000 Graphics Cards

Get HP j6700 - Workstation PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

j6700/j6000 Graphics Cards Your j-Class Workstation's PCI (Peripheral Connect Interface) assembly cage has three 64-bit, 4x, 3.3v, 66 MHz card slots, providing I/O expansion capabilities. See Figure 0-1. Use the Primary Graphics Slot for the highest performance graphics card. Use the Secondary Graphics Slot for the second graphics card and the remaining slot for any additional supported card. Figure 0-1 j6700 PCI Card Slot Numbering Primary Graphics Card Slot Secondary Graphics Card Slot NOTE: You will need a T-15 Torx driver or ﬂathead screwdriver to remove the I/O slot bulkhead screws. Here are the steps required to remove a graphics card from your j6700 or j6000 computer. 1. Power down the system, and unplug the power cord from the electrical outlet. 2. Open the side panel of the system unit. See your workstation's User's Guide for detailed instruc-

Section	Page
System Prerequisites	1
1. Hardware requirements - The A7789A Fire GL-UX card is supported only on hp j6000 and HP PA-RIS...	1
2. O.S. requirements - The prerequisite OS software must be installed before the Fire GL-UX card ...	1
Monitor Support	2
Table01. Fire GL-UX Supported Monitors	2
Software Installation Instructions	3
Making Software And Device-specific Changes	3
Removing/Replacing Cards	3
j6700/j6000 Graphics Cards	4
1. Power down the system, and unplug the power cord from the electrical outlet.	4
2. Open the side panel of the system unit. See your workstation’s User’s Guide for detailed instr...	4
3. Slide the card into the appropriate slot (see #3 above), ensuring that you align Bulkhead Pin(...	5
4. Plug the AC power cord into the workstation and power on the workstation.	5
5. Refer to your workstation documentation for instructions on using the HP-UX System Administrat...	5
c3650 and c3700 I/O Cards	5
1. Locate the appropriate slot for the I/O card that is to be installed.	7
2. Insert the card into the slot you have chosen with the bulkhead appropriately positioned. See ...	7
3. Replace the card retainer by placing the bottom retainer hook in the slot on the air divider a...	7
4. Close the left side panel of the system unit by following the procedure in the User’s Guide. A...	7
HP Hardware Warranty	8
Software Support	8
Regulatory Information	8

Match case Limit results 1 per page

j6700/j6000 Graphics Cards

Your j-Class Workstation’s PCI (Peripheral Connect Interface) assembly cage has three 64-bit, 4x,

3.3v, 66 MHz card slots, providing I/O expansion capabilities. See Figure 0-1.

Use the Primary Graphics Slot for the highest performance graphics card. Use the Secondary

Graphics Slot for the second graphics card and the remaining slot for any additional supported card.

Figure 0-1

j6700 PCI Card Slot Numbering

NOTE: You will need a T-15 Torx driver or ﬂathead screwdriver to remove the I/O slot bulkhead

screws.

Here are the steps required to remove a graphics card from your j6700 or j6000 computer.

Power down the system, and unplug the power cord from the electrical outlet.

Open the side panel of the system unit. See your workstation’s

User’s Guide

for detailed instruc-

Primary Graphics Card Slot

Secondary Graphics Card Slot