HP m9510f Upgrading and Servicing Guide - Page 12
Removing and Replacing Drives, Removing an optical drive
UPC - 884420537359
View all HP m9510f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Removing and Replacing Drives Your computer has several drives that you can replace or upgrade. See "Locating Components Inside the Computer" on page 7 for the drive types and locations. The hard disk drive is either a Serial ATA (advanced technology attachment) drive, which uses a narrow data cable, or a Parallel ATA drive, which uses a wide data cable. Select models have a second hard disk drive. CAUTION: Before you remove the hard disk drive, back up your personal files on the hard disk drive to an external storage device, such as a CD. Failure to do so will result in data loss. After replacing the hard disk drive, you must run System Recovery using the recovery discs to load the factory-installed files. For details about the recovery procedure, see the user documentation that came with your computer. You can add an optical drive into an empty lower optical drive bay. IMPORTANT: Before adding a new optical drive, make sure that it is compatible with the operating system. Also, make sure you have the correct software and drivers for the optical drive to work with the operating system. Removing an optical drive 1 Complete the procedures to prepare the computer to remove the side and front panels. See "Opening and Closing the Computer" on page 1. 2 Release the drive by pulling the latch out, away from the chassis, and then pulling the drive partway out of the front of the chassis. (The latch drive brackets secure the drives in their respective positions in the chassis.) 8 Upgrading and Servicing Guide