HP rp5450 HP DLPI Programmer's Guide - Page 83
DL_DISABMULTI_REQ, New State, Response, Reasons for Failure, Format
View all HP rp5450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
DLPI Primitives Local Management Primitives This message is valid in any state in which a local acknowledgment is not pending with the exception of DL_UNATTACHED. New State The resulting state is unchanged. Response If the enable request is successful, a DL_OK_ACK is sent to the DLS user. If the request fails, DL_ERROR_ACK is returned and the resulting state is unchanged. Reasons for Failure DL_BADADDR Address information was invalid or was in an incorrect format. DL_TOOMANY Too many multicast address enable attempts. Limit exceeded. DL_OUTSTATE Primitive was issued from an invalid state. DL_NOTSUPPORTED Primitive is known, but not supported by the DLS Provider. DL_SYSERR A system error has occurred as invalid events are requested. The UNIX error returned may be set to (not limited to) the errors listed in Table 2-2 on page 71. DL_DISABMULTI_REQ Requests the DLS Provider to disable specific multicast addresses on a per Stream basis. Format The message consists of one M_PROTO message block, which contains the following structure: Chapter 2 83