HP s7500mm HP CRT Monitor s7500mm - Page 4

CRT Monitor s7500mm Connecting the Monitor and Stand ✎ To identify the components on the multimedia speaker stand, refer to "Identifying the Multimedia Speaker Stand Components" in this document. 1. Turn off the computer and unplug the power cord. 2. Connect the monitor signal cable 1 to the computer's video port (video board, video card, or graphics card). 3. Connect the microphone connector on one end of the microphone/audio connectors cable 2 to the microphone input jack on the computer's sound card or microphone jack. Connect the other end of the microphone connector to the micicrophone input jack on the rear of the multimedia speaker stand. 4. Connect the audio connector on one end of the microphone/audio connectors cable 3 to the stereo output jack on the computer's sound card or audio jack. Connect the other end of the audio connector to the audio input jack on the rear of the multimedia speaker stand. 5. Connect the attached power cable of the multimedia speaker stand 4 to the rear of the monitor. 6. Connect the monitor power cord 5 to the power connector on the rear of the multimedia speaker stand and the other end into a nearby wall outlet. 7. Reconnect the computer power cord 6 into the wall outlet. 8. Turn on the computer and monitor. The hardware installation is now complete. 9. On the multimedia speaker stand, turn the on/off volume control clockwise until it clicks to turn on the sound. 10. Using the computer, start a sound program to play music or sound effects while you slowly turn the on/off volume control clockwise to adjust to your desired volume level. 4 www.hp.com