HP t5630 TeemTalk 7.0 User Manual - Page 228
National Code Settings, SBCS Code SBCS Character Set, code to use.
View all HP t5630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
IBM 5250 Display Emulation These options enable you to select the character set to be used. There are separate entries for the Single Byte Character Set (SBCS) and (if supported) Double Byte Character Set (DBCS). These should only be changed by the System Administrator. If they have been changed and you wish to restore the default settings, click the Defaults button at the bottom of the dialog. The table at the end of this section shows the default settings. National Codepage Settings Factory default: User Defined This specifies the type of national codepage to be used. Selecting User Defined will enable manual selection of the Codepage and Character Set using the following options. SBCS Codepage Factory default: 37 This is a numeric value specifying the single-byte character set codepage to use. SBCS Character Set Factory default: 697 This is a numeric value specifying the single-byte character set to use. DBCS Codepage Factory default: 0 This is a numeric value specifying the double-byte character set codepage to use. Font Factory default: Courier New This enables you to specify the font to be used for displaying characters. The available settings depend on the fonts installed. 212 Setup Options