HP x280n HP MediaSmart Connect x280n Installation and User Guide - Page 22

Step 2: Follow the Setup Wizard on Your HDTV This section describes how to select the HDTV resolution and start the wizard to configure HP MediaSmart Connect at the HDTV, and then how to install the software from the Installation CD and proceed with the setup at the computer. When using the remote control to operate the HP MediaSmart Connect, point the remote control at the remote control sensor on the front of the device, press a button on the remote control, and then wait for the device to respond. IMPORTANT: Note that some remote control button ! actions may take longer than others to complete. Be patient, and allow sufficient time for a response before pressing the next remote control button. The Installation CD installs the Microsoft® Windows Media Player (WMP) software, if it is not already installed. The WMP software uses your home network to stream photos, videos, and music to the HP MediaSmart Connect for viewing on your HDTV. You select which media folders on your computer you want to share with the HP MediaSmart Connect. Windows Media Player must be installed, and HP MediaSmart Connect must be allowed in order to display the media shared from your computer. These steps occur during the software installation. You can use any Universal Plug and Play (UPnP)-compliant server program to stream media to HP MediaSmart Connect. HP recommends and supports Windows Media Player 11. For information about using Windows Media Player 11, see "Chapter 7: Using Windows Media Player" on page 86. For a wireless network, you need the name or SSID of your network, and the security information (the WEP key or the WPA passphrase). Getting Started 22