Hikvision DS-D5024FC-C User Manual - Page 14

Overscan, Point to Point, Keypad

Get Hikvision DS-D5024FC-C PDF manuals and user guides View all Hikvision DS-D5024FC-C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Monitor • User Manual If Overscan is enabled, you can set the value of the top/bottom/left/right edge. The value indicates the covered units of different directions. Parameter Overscan Left Edge Right Edge Top Edge Bottom Edge Overscan Overscan Parameters Description Off/On Ranges from 0 to 100. Ranges from 0 to 100. Ranges from 0 to 100. Ranges from 0 to 100. Scale up/down the image. Three kinds of aspects are available: 16:9, 4:3, and point to point. Point to Point mode is only available when a VGA or HDMI signal is accessed. When no need to use keypad or the installation environment may extrude the keypad, you can set the Keypad as Off to lock it. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Monitor
•
User Manual
11
If
Overscan
is enabled, you can set the value of the top/bottom/left/right edge. The value indicates
the covered units of different directions.
Overscan
Overscan Parameters
Parameter
Description
Overscan
Off/On
Left Edge
Ranges from 0 to 100.
Right Edge
Ranges from 0 to 100.
Top Edge
Ranges from 0 to 100.
Bottom Edge
Ranges from 0 to 100.
Scale up/down the image. Three kinds of aspects are available: 16:9, 4:3, and point to point.
Point to Point
mode is only available when a VGA or HDMI signal is accessed.
When no need to use keypad or the installation environment may extrude the keypad, you can set
the
Keypad
as
Off
to lock it.