Hitachi 42PD5000 Owners Guide - Page 31
Optional Video Unit Function, INSTALLATION INSTRUCTIONS, Connecting to a Video Imaging Device
View all Hitachi 42PD5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
23 ENGLISH Optional Video Unit Function Additional functions when the optional video unit is installed are as follows INSTALLATION INSTRUCTIONS Connecting to a Video Imaging Device (1) Make sure that the power switch of the monitor is turned off. (2) Make sure that the power switch of the imaging device is turned off. (3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this device and the signal output terminal of the imaging device. Speaker (R) Monitor rear panel Speaker (L) To audio output terminals To component output terminals To audio output terminals To component output terminals To component input terminals To component input terminals To S video output terminal To composite output terminal To audio output terminals To composite input terminal To audio input terminals VTR S-video/Composite video Do not connect both plugs at the same time. Use either of them. Adaptor with Cable 20 18 16 14 12 10 8 6 4 2 21 19 17 15 13 11 9 7 5 3 1 Adaptor (32") (42") Power cord DVD player Set-Top Box ʢSbɹe-vuiɹdseeod.cannotʣ Video disc player Use if the video VTR equipment has an S video [An example of connecting video imaging devices] input terminal With RGB component setup To component video equipments. Please use the connection cable suitable for the terminal form of video equipment. • If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality. (If an S video input terminal and a video input terminal of AV3 connect to the monitor at the same time, S video input would govern.) • If the OUTPUT (MONITOR) terminal is connected to an external monitor with a 75 Ohm terminal, it is possible to view the same image as on the main unit. But it is possible to monitor only the composite video signal from AV1, AV2, AV3 or AV4 input that is displayed on the screen at the time. • If the adaptor is applied to AV4 input as shown in the drawing, it is not possible to receive RGB signal. Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details. ) Terminal Signal AV1 AV2 AV3 AV4 RGB1 RGB2 RCA/SCART CVBS S-video Component ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ RGB ˓ ˓ DVI PC STB ˓ ˓ D-sub RGB Component Remarks Refer to Setup Menu. Refer to Setup Menu. Refer to Setup Menu. ˓ ˓ Refer to Setup Menu. (˓ "WBJMBCMF