Hitachi CJ110MV Instruction Manual - Page 15
Selection Of Blades, Housing The Allen Wrench - case
UPC - 717709010543
View all Hitachi CJ110MV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English When cutting stainless steel plates, adjust the unit as described below: 1. Adjust the speed Blade Thickness of material Dial Scale No. 97 1/16" - 5/32" (1.5 mm - 2.5 mm) Middle groove position between scales "2" and "3" NOTE: Dial scale reading is for reference only. The higher the speed is, the quicker the material is cut. But the service life of the blade will be reduced in this case. When the speed is too low, cutting will take longer, although the service life will be prolonged. Make adjustments as desired. 2. Set the orbital position to "0" NOTE: When cutting use cutting fluid (oil base cutting fluid) to prolong the blade's service life. SELECTION OF BLADES ⅜ Accessory blades To ensure maximum operating efficiency and results, it is very important to select the appropriate blade best suited to the type and thickness of the material to be cut. Three types of blades are provided as standard accessories. The blade number is engraved in the vicinity of the mounting portion of each blade. Select appropriate blades by referring to Table 1 (page 18). HOUSING THE ALLEN WRENCH ⅜ It is possible to house the axiliary allen wrench on the base (see Fig. 17). I Allen wrench II Base Fig. 17 15