Hitachi CMP4212U Owners Guide - Page 37
OPERATING INSTRUCTIONS continued, Displaying MULTI PICTURE, Input Signal Screen Display
View all Hitachi CMP4212U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
OPERATING INSTRUCTIONS (continued) ENGLISH Displaying MULTI PICTURE If the PinP button on the remote control is pressed MULTI PICTURE will display. Activating the P-in-P mode from the RGB input screen RECALL button PinP button VOL RGB 1 RGB 2 MUTE VOL AV1 AV2 AV3 AV4 AUTO PinP SIZE RECALL RECALL button Pressing the PinP button one time will display 2 pictures. • This mode can be available from RGB1(DVI-PC) and RGB2(RGB) input. • The speaker icon can be shifted left and right by pressing the and SELECT buttons; the audio of the video will be output from the side on which the speaker icon is located. • The sub-screen position can be selected up and down by pressing SELECT buttons. RGB2 AV1 • The sub-screen can be selected with the AV1, AV2, AV3, and AV4 buttons from the status that the speaker icon appears on the left side of AV✱ as shown in the diagram to the right. (Subscreen) • Pressing the PinP button again or the RETURN button will cancel the 2 pictures display. • "Frequency Mode" in the Setup Menu should be set to Movie when sub-screen is the component signal of 1080i/50 or 1080i/60. AV1: Displays the VIDEO input signal of the sub-screen. Activating the Split mode from the video input screen MENU OK RETURN button ID ID SET 2 Pictures (Split) Pressing the PinP button one time will display 2 pictures. • The speaker icon can be shifted left and right by pressing the and AV1 AV2 SELECT buttons; the audio of the video will be output from the side on which the speaker icon is located. • The same video input mode cannot be selected for both screens at the same time. • Pressing the PinP button again or the RETURN button will cancel the 2 pictures display. • When the Video input is set to RGB Video, this Split mode is not possible. • Refer to the table for 2 pictures (Split) mode. Input terminal Sub Main AV1 ʙAV4 PAL-N NTSC-M , PAL-M 576i, 576p 480i, 480p AV1 AV2 1080i/50 1080i/60 720p/60 RGB1 STB RGB2 Component AV1ʙAV4 PAL-N NTSC-M PAL-M ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ 576i 576p ˓ ˓ AV1, AV2 RGB1 480i 480p 1080i/50 1080i/60 720p/60 STB ˓ ˓ ˓ ˓ ˓ ˓ ˓ ˓ RGB2 Component ˓˓ ˓ ˓ ˓ (˓ "WBJMBCMF) Main Sub NOTE • Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not change to power save mode. • Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time. Input Signal Screen Display The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor. • The display will go out in approximately 6 seconds. VIDEO Off-timer On-timer OFF -- -- Min AV1 Composite Input mode Signal mode