Hitachi CP-RX78 User Manual - Page 84

About disposal of a lamp

Get Hitachi CP-RX78 PDF manuals and user guides View all Hitachi CP-RX78 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 84 highlights

ENGLISH Replacing the lamp (continued) HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE WARNING ŹThe projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. In addition, if the bulb bursts, it is possible IRUVKDUGVRIJODVVWRÀ\LQWRWKHODPSKRXVLQJDQGIRUJDVFRQWDLQLQJPHUFXU\DQG GXVWFRQWDLQLQJ¿QHSDUWLFOHVRIJODVVWRHVFDSHIURPWKHSURMHFWRU¶VYHQWKROHV ŹAbout disposal of a lamp: This product contains a mercury lamp; do not put it in a trash. Dispose of it in accordance with environmental laws. ‡)RUODPSUHF\FOLQJJRWRwww.lamprecycle.org (in the US). ‡)RUSURGXFWGLVSRVDOFRQVXOW\RXUORFDOJRYHUQPHQWDJHQF\ or www.eiae.org (in the US) or www.epsc.ca (in Canada). )RUPRUHLQIRUPDWLRQDVN\RXUGHDOHU ‡ ,I WKH ODPS VKRXOG EUHDN LW ZLOO PDNH D ORXG EDQJ ZKHQ LW GRHV  unplug the power cord from the outlet, and make sure to request a replacement lamp from your local dealer. Note that shards of glass could damage the projector's internals, or cause injury during handling, so please do not try to clean the projector or replace the lamp yourself. Disconnect ‡ ,I WKH ODPS VKRXOG EUHDN LW ZLOO PDNH D ORXG EDQJ ZKHQ LW GRHV  the plug from the ventilate the room well, and make sure not to inhale the gas or fine power particles that come out from the projector's vent holes, and not to get outlet them into your eyes or mouth. ‡%HIRUHUHSODFLQJWKHODPSWXUQWKHSURMHFWRURIIDQGXQSOXJWKHSRZHU cord, then wait at least 45 minutes for the lamp to cool sufficiently. Handling the lamp while hot can cause burns, as well as damaging the lamp. ‡ Never unscrew except the appointed (marked by an arrow) screws. ‡ Do not open the lamp cover while the projector is suspended from a ceiling. This is dangerous, since if the lamp's bulb has broken, the shards will fall out when the cover is opened. In addition, working in high places is dangerous, so ask your local dealer to have the lamp replaced even if the bulb is not broken. ‡ 'R QRW XVH WKH SURMHFWRU ZLWK WKH ODPS FRYHU UHPRYHG$W WKH ODPS replacing, make sure that the screws are screwed in firmly. Loose screws could result in damage or injury. ‡ 8VH RQO\ WKH ODPS RI WKH VSHFL¿HG W\SH 8VH RI D ODPS WKDW GRHV QRW PHHW WKH ODPSVSHFL¿FDWLRQVIRUWKLVPRGHOFRXOGGDPDJHRUVKRUWHQWKHOLIHRIWKLVSURGXFW ‡ ,I WKH ODPS EUHDNV VRRQ DIWHU WKH ILUVW WLPH LW LV XVHG LW LV SRVVLEOH that there are electrical problems elsewhere besides the lamp. If this happens, consult your local dealer or a service representative. ‡Handle with care: jolting or scratching could cause the lamp bulb to burst during use. ‡8VLQJWKHODPSIRUORQJSHULRGVRIWLPHFRXOGFDXVHLWGDUNQRWWROLJKW up or to burst. When the pictures appear dark, or when the color tone is poor, please replace the lamp as soon as possible. Do not use old (used) lamps; this is a cause of breakage. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
13
ENGLISH
HIGH VOLTAGE
HIGH TEMPERATURE
HIGH PRESSURE
WARNING
The projector uses a high-pressure mercury glass lamp. The lamp
can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or
worn over time. Note that each lamp has a different lifetime, and some may burst or
burn out soon after you start using them. In addition, if the bulb bursts, it is possible
About disposal of a lamp:
This product contains a mercury lamp; do not put
it in a trash. Dispose of it in accordance with environmental laws.
www.lamprecycle.org (in the US).
or www.eiae.org (in the US) or www.epsc.ca (in Canada).
unplug the power cord from the outlet, and make sure to request a
replacement lamp from your local dealer. Note that shards of glass
could damage the projector’s internals, or cause injury during handling,
so please do not try to clean the projector or replace the lamp yourself.
ventilate the room well, and make sure not to inhale the gas or fine
particles that come out from the projector's vent holes, and not to get
them into your eyes or mouth.
cord, then wait at least 45 minutes for the lamp to cool sufficiently.
Handling the lamp while hot can cause burns, as well as damaging the lamp.
Never unscrew except the appointed (marked by an arrow) screws.
Do not open the lamp cover while the projector is suspended from a ceiling.
This is dangerous, since if the lamp’s bulb has broken, the shards will fall out
when the cover is opened. In addition, working in high places is dangerous, so
ask your local dealer to have the lamp replaced even if the bulb is not broken.
replacing, make sure that the screws are screwed in firmly. Loose
screws could result in damage or injury.
that there are electrical problems elsewhere besides the lamp. If this
happens, consult your local dealer or a service representative.
Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
up or to burst. When the pictures appear dark, or when the color tone
is poor, please replace the lamp as soon as possible. Do not use old
(used) lamps; this is a cause of breakage.
Disconnect
the plug
from the
power
outlet
Replacing the lamp (continued)