Hitachi CP-WX1100 User Manual - Page 11
Connecting with your devices
View all Hitachi CP-WX1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Setting up Connecting with your devices Before connecting the projector to your devices, check the manual of the device in order to make sure that the device is suitable to connect with this projector and to check what is required for the connection. Consult your dealer when the required accessory did not come with the product or the accessory is damaged. It may be regulated under some standard. After making sure that the projector and the devices are turned off, perform the connection, according to the following instructions. Refer to the figures in subsequent pages. NOTE • For this product, the optional cable cover is ready to be purchased. To place an order for it, please tell your dealer the type name of it (&77). WARNING ►Use only the accessories specified or recommended by manufacturer. Modify neither a projector nor accessories. ►Do not connect or disconnect the projector with devices while they are connected to a power supply except for the cases directed by the manuals of devices. CAUTION ►Some connecting cable may have to have a specific length, or a ferrite core at the end to connect to the projector, under the regulation of electro-magnetic interference. When a ferrite core is attached to the specified cable only at one end, connect to the projector the end that the ferrite core is attached at. ►Be careful not to set a connector into a wrong port or with a wrong way. ►Be careful not to damage the cables. Route the cables not to be stepped on and pinched out. NOTICE ►Do not turn your device on prior to the projector, except for the cases directed by the manuals of devices. (continued on next page) 11