Hitachi CP-X10000 User Manual - Page 34
IMAGE menu
View all Hitachi CP-X10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
IMAGE menu IMAGE menu From the IMAGE menu, items shown in the table below can be performed. Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table. Item Description Using the ▲/▼ buttons switches the mode for aspect ratio. For a COMPUTER signal NORMAL ó 4:3 ó 16:9 ó 16:10* ó SMALL* ó NATIVE* ó FULL* For an HDMI or DVI-D signal NORMAL ó 4:3 ó 16:9 ó 16:10* ó 14:9 ó SMALL* ó NATIVE* ó FULL* ASPECT For a Video signal, S-video signal or component video signal 4:3 ó 16:9 ó 16:10* ó 14:9 ó SMALL* ó NATIVE* ó FULL* For no signal 4:3 (fixed, except CP-WX11000) / FULL (fixed, CP-WX11000) • *16:10 / FULL: CP-WX11000 only. NATIVE: Except CP-X10000. SMALL: Except CP-WX11000. • The NORMAL mode keeps the original aspect ratio of the signal. OVER SCAN Using the ◄/► buttons adjusts the over-scan ratio. Small (It magnifies picture) ó Large (It reduces picture) • This item can be selected not only for a video, s-video and component signal but also HDMI and DVI-D signal when the VIDEO is selected on the DIGITAL FORMAT item (37). • When this adjustment is too large, certain degradation may appear at the frame area of the picture. In such a case, please adjust small. V POSITION Using the ◄/► buttons adjusts the vertical position. Down ó Up • Over-adjusting the vertical position may cause noise to appear on the screen. If this occurs, please reset the vertical position to the default setting. Pressing the RESET button when the V POSITION is selected will reset the V POSITION to the default setting. • When this function is performed on a video signal, s-video signal, or component video signal of 480i@60 or 576i@50 input the range of this adjustment depends on the OVER SCAN (above) setting. It is not possible to adjust when the OVER SCAN is set to 10. • This item cannot be selected for an HDMI or DVI-D signal. H POSITION Using the ◄/► buttons adjusts the horizontal position. Right ó Left • Over-adjusting the horizontal position may cause noise to appear on the screen. If this occurs, please reset the horizontal position to the default setting. Pressing the RESET button when the H POSITION is selected will reset the H POSITION to the default setting. • When this function is performed on a video signal, s-video signal, or component video signal of 480i@60 or 576i@50 input the range of this adjustment depends on the OVER SCAN (above) setting. It is not possible to adjust when the OVER SCAN is set to 10. • This item cannot be selected for an HDMI or DVI-D signal. 34 (continued on next page)