Hitachi CPA100 User Manual - Page 17

Power on/off Turn off the power Turn the projector off after turning off the other connected devices, unless mentioned in the manuals. For this projector, follow the procedure below. 1. Press the STANDBY/ON button (on the projector or remote control). The "Power off?" dialog appears on the screen for about 5 seconds. 2. Confirm that there is nothing that the lens door hits while closing. Then press the STANDBY/ON button again while the message appears. The projection lamp goes off, the lens door closes, and the POWER indicator begins to blink orange. POWER indicator STANDBY/ON button LAMP TEMP POWER STANDBY/ON INPUT ● For cooling the projector down, wait for the POWER indicator to stop blinking and turn steady orange. The projector can be turned off without waiting for cooling down. However, the manufacture recommends cooling the projector down enough. Do not turn the projector on for about 10 minutes or more after turning it off to prevent shortening its life. Power switch STANDBY/ON button 3. Press the side marked " " of the power switch, as the power-off position. The POWER indicator goes off. When you will not use the projector for a long while, unplug and separate the power cord from the power outlet, for safety purposes. NOTE • Use the shutdown switch (70) only when the projector is not turned off by normal procedure. • Do not turn the projector on for about 10 minutes or more after turning it off. Turning the projector on again too soon could shorten the lifetime of some consumable parts of the projector. CAUTION ►Be careful not to pinch your finger with the lens door, to prevent an injury. ►Do not touch the lamp cover or approach the exhaust vents while using the projector and for a while after use, to prevent a burn. 17