Hitachi CPX2510 User Manual - Page 42

OPTION menu OPTION menu From the OPTION menu, items shown in the table below can be performed. Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table Item AUTO SEARCH AUTO KEYSTONE DIRECT ON Description Using the ▲/▼ buttons turns on/off the automatic signal search function. ON  OFF When the ON is selected, detecting no signal automatically cycles through input ports in the following order. The search is started from the current port. Then when an input is found, the projector will stop searching and display the image. COMPUTER IN1  COMPUTER IN2 VIDEO
 S-VIDEO  COMPONENT (Y, Cb/Cr, Cr/Pr) Using the ▲/▼ buttons turns on/off the automatic keystone function. ON  OFF ON : Automatic keystone distortion correction will be executed whenever changing the slant of the projector. OFF : This function is disabled. Please execute the AUTO KEYSTONE EXECUTE in the SETUP menu for automatic keystone distortion correction. • When the projector is suspended from the ceiling this feature will not function properly so select the OFF. • This function will be unavailable when the Transition Detector is on (50). Using the ▲/▼ buttons turns on/off the DIRECT ON function. ON  OFF When set to the ON, the lamp in projector will be automatically turned on without the usual procedure (14), only when the projector is supplied with the power after the power was cut while the lamp was on. • This function does not work as long as the power has been supplied to the projector while the lamp is off. • After turning the lamp on by the DIRECT ON function, if neither input nor operation is detected for about 30 minutes, the projector is turned off, even though the AUTO OFF function (43) is disabled. (continued on next page) 42