Hitachi DH50MB Instruction Manual - Page 11
HOW TO USE - 2 sds max shank rotary hammer
![]() |
UPC - 717709005600
View all Hitachi DH50MB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English (2) To attach the tool (SDS max shank), insert it into the hole until it contacts the innermost end of the hole as illustrated in Fig. 2. If you continue to turn the tool with slight pressure, you can feel a spot where there is a hitch. At that spot, pull the grip to the direction of an arrow mark and insert the tool all the way until it hits the innermost end. Releasing the grip reverts the grip and secures the tool in place. (3) To remove the tool, fully pull the grip in the direction of the arrow and pull out Front Cap the tool. 7. Regulating the number of rotations and hammering (Fig. 3) This hammer drill is equipped with a built-in electronic control circuit that can adjust and regulate the number of rotations and times of hammering. This hammer drill can be used by adjusting the dial, depending upon the contents of operation, such as boring holes into fragile materials, chipping, centering, etc. The scale '1' of the dial is designed for a minimum speed with the number of 120 rotations per minute and 1,200 times of blow per minute. The scale '5' is designed for a maximum speed with the number of 250 rotations per minute and 2,500 times of blow per minute. Tool Part of SDS max Shank Grip Fig. 2 5 Dial Fig. 3 CAUTION: Do not adjust the dial during operation. Doing so can result in injury because the rotary hammer must be held by only one hand, disabling the steady control of the rotary hammer. HOW TO USE 1. How to drill holes (Fig. 4) (1) Pull the switch trigger after applying the drill bit tip to the drilling position. (2) It is unnecessary to forcibly press the rotary hammer main body. It is sufficient to slightly press the rotary hammer to an extent that clips are freely discharged. Fig. 4 11
![](/manual_guide/products/hitachi-dh50mb-instruction-manual-224806d/11.png)