Hitachi HTS543232L9A300 Specifications - Page 35
Nonoperating vibration, Operating shock, Nonoperating shock
View all Hitachi HTS543232L9A300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
6.5.2 Nonoperating vibration 5K320 SATA OEM Specification The disk drive withstands the following vibration levels without any loss or permanent damage. 6.5.2.1 Random vibration The test consists of a random vibration applied in each of three mutually perpendicular axes for a duration of 15 minutes per axis. The PSD levels for the test simulating the shipping and relocation environment is shown below. Hz (m2/sec4)/Hz 2.5 0.096 5 2.88 40 1.73 500 1.73 Table 19. Random Vibration PSD Profile Breakpoints (nonoperating) Note: Overall RMS level of vibration is 29.50 m/sec2 (3.01 G). 6.5.2.2 Swept sine vibration 49 m/sec2 (5 G) (zero-to-peak), 10 to 500 to 10 Hz sine wave 0.5 oct/min sweep rate 25.4 mm (peak-to-peak) displacement, 5 to 10 to 5 Hz 6.5.3 Operating shock The hard disk drive meets the criteria in the table below while operating under these conditions: The shock test consists of 10 shock inputs in each axis and direction for a total of 60. There must be a minimum delay of 3 seconds between shock pulses. The disk drive will operate without a hard error while subjected to the following half-sine shock pulse. Duration of 1 ms 1960 m/sec2 (200 G) Table 20. Operating shock Duration of 2 ms 3920 m/sec2 (400 G) The input level shall be applied to the normal disk drive subsystem mounting points used to secure the drive in a normal system. 6.5.4 Nonoperating shock The drive withstands the following half-sine shock pulse without any data loss or permanent damage. Duration of 1 ms 9800 m/sec2 (1000 G) Table 21. Nonoperating shock Duration of 11 ms 1470 m/sec2 (150 G) The shocks are applied for each direction of the drive for three mutually perpendicular axes, one axis at a time. Input levels are measured on a base plate where the drive is attached with four screws. 35