Hitachi NV75AG Instruction Manual - Page 17

English MAINTENANCE NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer. Some illustrations in this Manual may show details or attachments that differ from those on your own Nailer. MAINTENANCE AND INSPECTION Read section titled "SAFETY" (pages 4 - 7). WARNING ⅷ Disconnect air hose and remove all nails from Nailer when: 1) doing maintenance and inspection; and 2) clearing a jam. 1. Clearing a jam Remove a jammed nail in the following order: 1 DISCONNECT AIR HOSE. 2 Open the nail guide. 3 Insert a rod into the outlet. Tap the rod with a hammer. Hammer 2. Inspecting the push lever 1 DISCONNECT AIR HOSE. 2 Clean the push lever sliding part. Lubricate it with Hitachi pneumatic tool lubricant. Lubricate 1 Disconnect air hose 3. Inspecting the feeders 1 DISCONNECT AIR HOSE. 2 Clean the knob sliding part. Lubricate it with Hitachi pneumatic tool lubricant. Rod Outlet 1 Disconnect air hose 4 Remove the jammed nail with a slotted screw driver. Knob Nail Guide 1 Disconnect air hose 3 Open the nail guide and remove dust. Lubricate the sliding groove of the feeder and shafts. Nail Stopper (A) Nail Slotted Screw Driver 5 Cut the deformed collated wire with nippers. Correct the deformation. 6 In case of frequent jam, contact a Hitachi authorized service center. Nail guide Nail Stopper (B) Shaft Feeder Nose 4 Lubricate the feeding surfaces of the nose and the nail guide after cleaning. This promotes smooth operation and prevents rust. - 17 -