Hitachi VT-F380A Owners Guide - Page 24
More About Channel Selections, Removing Channels, Adding Channels, To Add or Erase Channels,
View all Hitachi VT-F380A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Getting Started (Initial Setup) to enter the correct setup. The day of the week is set automatically. More About Channel Selections Your VCR is capable of receiving 68 broadcast TV channels (VHF 2-13, UHF 14-69) and 125 cable channels (CATV 1-125). When you press 7 on the Initial Setup screen, the tuner automatically cycles through all available channels in your area and places them in memory. This takes 2-3 minutes. You can watch the progress on the VCR's display - when the channel numbers stop changing, programming is complete. Only when the power goes out for more than 1 hour you do need to preset the channels again. In some areas channels cannot be switched when CATV1 is selected. Then, select CATV2 in your Initial Setup screen. For convenience, the TV channel numbers should match those programmed into the VCR. If your TV has automatic channel programming, set it on the same mode - ANT, CATV1 or CATV2 - and let it reprogram to match the VCR. Once channels are preset, you can use the up and down CHANNEL buttons to move through the active channels. Or you can press the number buttons to move quickly between channels that are far apart. Removing Channels You may not want to keep all the stations the auto-programmer selects, since you may prefer to have only a few favorite channels in the tuner's memory. Or, you may want to delete from memory a weak or unused channel that the tuner picked up. Erased channels cannot be selected by the up and down CHANNEL buttons but can still be selected by using the numbered buttons 0 to 9 and 100/ENT. Adding Channels Occasionally the auto-programming may skip an active channel because the antenna was pointed in the wrong direction or the channel had a weak signal or was "off the air" at the time of programming. Or you may change your mind about a channel you removed from memory. To Add or Erase Channels Press GUIDE, then press 4 to bring up the Initial Setup screen. Item 8 lets you add or delete channels. Use the number buttons to enter the channel you want to change, then press STOP to delete it or press PLAY to add it. Choosing a Mode for Audio Playback Choose between hi-fi and linear modes, depending on your needs. HIFI is the preferred setting because it works for all tapes whether they were recorded in hi-fi or linear modes. If the audio sounds distorted or unusual or there is no audio, try the LINEAR option. 24